Elfers is the old citrus settlement between New Port Richey and Holiday, with a post office since 1909, a railroad since 1913, and the Anclote River running through it. The houses are a mix of 1950s frame cottages, 1960s and 1970s block ranches, and manufactured homes along the river roads. Elevation is about 33 feet on the high ground and a lot less along the water.
The river is the story here. After Milton, the Anclote at Little Road crested at 26.57 feet on October 11, 2024, about a foot short of the record, and Anclote River Estates was under an evacuation order. The same houses flooded after Irma in 2017. River water is fresh and slow, and it soaks a block wall from the outside for days instead of hours.
Homeowners in Elfers reach an independent local mold provider through this site's phone line. The provider reads the house and explains what it needs. The site sets up the call.
A house that stood in river water for two days usually needs whole-home mold remediation, because every ground-floor wall got wet from the outside in. A single room that took water is mold removal. Once the block reads dry, mold damage repair rebuilds it, and the crew will ask whether the rebuild needs a flood-zone review first.
The National Weather Service gauge for the Anclote River near Elfers at Little Road is the number everyone on the river roads watches; evacuation of the Estates is recommended at 23 feet. The West Pasco Historical Society museum in nearby New Port Richey keeps the photographs of every flood before this one.
Call (727) 353-1690 to be connected with a local mold provider serving Elfers.
Containment, negative air, and removal of wet drywall, baseboard, and insulation, then HEPA cleaning and drying down to the block.
Dark growth handled by extent and moisture, not color: sealed room, porous material out, hard surfaces cleaned, source fixed.
A house that took surge water or sat closed all summer, mapped room by room, contained in zones, and cleared as one project.
Growth on roof decking and trusses above a leak or a sweating duct, cleaned and treated with the roof or venting problem addressed.
Coil, drain pan, condensate line, cabinet, and ducts cleaned or replaced when the musty smell rides in on the air handler.
Tracking a musty smell that outlasted the cleanup to the wet material behind it, removing that, then treating the air and surfaces.
Growth behind a vanity, under a tub, or in a ceiling that never dries, removed with the leak or the exhaust problem fixed first.
Drywall, trim, cabinet bottoms, and flooring put back after removal, only once the slab and block read dry and the source is fixed.